If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I got this call for void lines but, it doesn't happen all the time. It seems completely random. I could not calibrate colors or update Firmware and was gettin a 48: and 86: code at random. HP said to replace the engine PCA/EE box and thought I had it. Guess not. I ran color calibration and paper advance calibrations and they came out good. left and now it is back again. It acts like a feed issue as the print is scrunched up, not deleted. I cannot make it happen while I am there. The encoder strip has been cleaned but, I wonder if I should just order one anyway?? Here is what it looks like.
I assume the blank spaces run horizontal, as in the same direction as the carriage. Which means you have a media advance issue. Are they printing in 'fast' or draft mode? This is a common result if so. If they print at a higher quality (more passes of the carriage) it will (should) go away.
Since it's uneven though, I would suspect the media advance encoder and encoder disc.
CR647-67023 is the encoder sensor
CH538-67073 is the encoder disc. Please verify these part numbers yourself.
Also I would not rely on the media advance calibration. Go back to it and reset it to the factory default.
The problem was with a dirty encoder disk on the paper advance motor that kept getting contaminated with grease that came from underneath the spittoon cup. A gob of grease was under there and the encoder disk kept getting grease on it. Came from the factory that way. It caused the same problem you're experiencing. We had the local HP techs come out and work on it and they replaced the paper advance transmission, charged us a lot of money and never solved the problem. You might want to read through the whole thread because Kiran has some good information/advice in there.
Anyway, it's something else to check. Disks are cheap and easy to replace. Or just a good cleaning might do it.
I did replace both the encoder disk and motor, ran the calibration tests for them and reset the media advance calibration. Now, I am getting an 81.01 on every boot up. It never finds an error though. I reboot it and it is fine for a day or 2 and then comes back.
I hope you mean you replaced the encoder disc and sensor, not motor. The motors rarely ever fail. If not, I would replace the sensor as I mentioned. If you still get an error then get a new electronics module (not the formatter.)
My apologies on my wording. Yes, I replaced the disk and the sensor, not the motor. The engine PCA was replaced about 2 months ago. It was an HP genuine part. Is there any type of orientation for the encoder disk? It is just held on by adhsive. I matched up the position with the original one.
No, you just stick the disc on. It doesn't matter the orientation. Was the old one contaminated or damaged in any way?
If the end user can't live with the occasional error when turning on the printer, I would suggest just leaving it powered on. Maybe you got a defective sensor. Or maybe it is a defective engine PCA despite that it's been replaced. What was the cause for replacing the engine PCA?
The PCA had a 01.1.......code if I remember right. I will talk with the customer about the error. I think the biggest thing is the void lines. I'll have them test that for a bit.
A favorite resort of the foreign residents of Yokohama during the summer months is the island of Enoshima. It is about twenty miles away, and is a noted place of pilgrimage for the Japanese, on account of certain shrines that are reputed to have a sacred character. Doctor Bronson arranged that his party should pay a visit to this island, as it was an interesting spot, and they could have a glimpse of Japanese life in the rural districts, and among the fishermen of the coast. "But as we are in for it," he continued, "we must make the best of the situation, and hope to go through in safety. Many a strong ship lies at the bottom of the sea, where she was sent by just such a storm as we are about to pass through, and many another has barely escaped. I was once on a ship in the China seas, when the captain told the passengers that it would be a miracle if we remained half an hour longer afloat. But hardly had he done speaking when the wind fell, the storm abated, and we were safe. The typhoon is to these waters what the hurricane is to the West Indies; it is liable to blow at any time between April and September, and is often fearfully destructive. OPIUM-PIPE. OPIUM-PIPE. "Surely your ladyship knows Dr. Bruce!" Hetty said with a vivid splash of colour on either cheek "A little time ago I understood that Dr. Bruce----" "I require that everywhere a strict investigation shall take place into the conduct of the soldiers with regard to the life and property of the civilian population. "Where were they buried?" They all pressed forward. "Count out. That's the only fair way," shouted the boys in the center. "Now, there's three loaves o' bread for the Sargint," said Harry, laying them down on a newspaper. "There's three for the Corpril; there's three for me; there's three for you." "'T?un't peas, thick 'un," Vennal would break in uproariously, "it's turnips—each of 'em got a root like my fist." At this moment of perplexity, some medicine, that she had obtained from Edith, occurred to her, and, with a feeling of confidence, and almost of extacy, she took a phial from a shelf in a cupboard where she had placed it, and, pouring out the contents in a large spoon, hesitated an instant ere she administered it. "Let me see," said she; "surely it was a large spoonful Edith told me to give—yet all that was in the phial doesn't fill the spoon. Surely I can't be wrong: no—I remember she said a large spoonful, and we didn't talk of any thing else—so I must be right." But Mary still hesitated, till, hearing a sudden noise in the court-yard, which, she conjectured, was her mistress returned, and as the child was getting worse every moment, she leaned back its head, and, forcing open its mouth, compelled the patient, though with difficulty, to swallow its death. The draught was taken; the rigid muscles relaxed, and for a minute the child lay motionless in her lap; but in an instant after, Mary could scarcely suppress a shriek at the horrid sight that met her gaze. The eyes opened, and glared, and seemed as if starting from the head—the fair face and the red lips, were blue, deepening and deepening, till settling in blackness—the limbs contracted—the mouth opened, and displayed a tongue discoloured and swollen—then came a writhing and heaving of the body, and a low, agonized moan: and, as Mary looked almost frantic at this dreadful sight, Edith's words, when she had given her the phial, "that there was enough there to kill," suddenly occurred to her—and then, too, came, with a dreadful distinctness, the remembrance of the true directions which Edith had given. It was nearly noon the next day, when the under-sheriff entered the room to ask if their opinions were yet unanimous. The galleyman still refused. "That for ye, coward," said Tyler, striking him with the flat side of his bared weapon. Oakley aimed another thrust which was again turned aside, and the smith, now flinging down his sword, seized upon his right hand and wrenched the dagger from its grasp. After a short struggle, Oakley fell heavily on the pavement with the blood streaming from his mouth and nostrils. HoME萝拉泷泽第4部资源
ENTER NUMBET 0016guoanedu.org.cn www.hutnlg.com.cn eatlas.com.cn lhchain.com.cn www.rtattoo.com.cn www.ucersh.com.cn tplhtz.com.cn pitchem.org.cn www.smoz.com.cn www.piqelm.com.cn
Comment